#KORG POLY 800 POWER SUPPLY HOW TO#

The key should snap out of the metal chassis, then you can move it further forward, and lift it out of the keybed. (If you need to remove a black key, you will first need to remove the two surrounding white keys - otherwise you won't be able to push the black key forward.) There are two tabs that secure it to the metal chassis, and they will need to spread slightly to release the key. Then, press with with your finger against the back of the key, pushing toward the front. Depress the back of the key, and it will go down about 1/4-inch. Once the keyboard's top panel is open, a key is easy to remove. Korg EPS-1 (slightly different key, but same technique) This information applies to the following synthesizers:

#KORG POLY 800 POWER SUPPLY HOW TO#

How to Replace and Repair Dead Keys on a Vintage Synthesizer Using K32U Keys This page and its contents are copyrighted by Syntaur Productions, and may not be copied or distributed without written permission. If you do not feel comfortable or competent in performing these tasks, we strongly recommend taking your keyboard to a You can be exposed to potentially fatal voltages. Unless otherwise indicated, the keyboard should be powered off and unplugged while these procedures are being done otherwise, You are solely responsible for any damages, problems, or injuries resulting from opening upДЄnd working on your equipment. Syntaur offers this information as a free service,ДЄnd makes no warranties of any kind regarding its use. Doing this type of work will almost certainly void any existing warranty coverage. Important Disclaimer: This information is intended to assist you in repairing your keyboard, which is presumably no longer PLEASE NOTE: While the photos here are representative for this procedure, they may not be of the specific equipment you are repairing. Repairing Dead Keys on a Vintage Synthesizer Using K32U Keys

Korg poly 800 power supply